Engineering Technology Major, B.S. (Biomedical Engineering Technology Concentration)

College of Business and Technology

Department of Engineering Technology, Surveying, and Digital Media

Engineering Technology Program Information

Main Office

213 Wilson Wallis Hall
ETSU Box 70552
Johnson City, TN 37614
(423) 439-7822 (Voice)
(423) 439-7830 (Fax - Admin)
(423) 439-7750 (Fax - Faculty)

email: johnsonk@etsu.edu

The Department of Engineering Technology, Surveying, & Digital Media, a unit of the College of Business and Technology [CBAT], is one of the largest and most academically diverse units of East Tennessee State University. The Department offers undergraduate degree programs in numerous concentrations, undergraduate minors in two areas, and graduate degree programs in three concentrations. Several programs are accredited through ABET. Additionally, there are many majors and/or programs that are available through the Academic Common Market allowing out-of-state students to enroll at ETSU at in-state tuition rates.

The department’s administrative and faculty offices are housed primarily in two buildings on the ETSU main campus. The Engineering Technology and Surveying & Mapping programs are located in Wilson-Wallis Hall while the Digital Media program is housed across State of Franklin Road from the main campus in the Scott M. Niswonger Digital Media Center.
www.etsu.edu/scitech/entc/index.htm

Work done for an Associate Degree will not substitute for 4xxx level work.

Biomedical Engineering Technology Concentration

This concentration is designed to prepare graduates to work as hospital-based biomedical engineering technologists.

General Program Information

To earn a degree from ETSU, there are specific course requirements established by ETSU, by the Tennessee Board of Regents (TBR), by each college, and by each department. All students must meet the degree requirements at each of these levels outlined in the following list:

University-level Degree and Graduation Requirements

• Degree and Graduation Requirements 
• Completion of a minimum of 120 credit hours is required.
• CSCI 1100 or the proficiency exam
• Proficiency Intensive Course Requirements
• California Critical Thinking Skills Test (CCTST)  (Senior Exit Exam)
• Additional Requirements for Transfer Students
• Second Bachelor Degrees
• Double Majors/Double Degrees

Total Credit Hours for Degree: 128

TBR General Education Requirements: 41 Credit Hours

Listed below are the categories and courses specified under TBR General Education Requirements. Note that certain courses are required for this degree, specific to this major. Thus, these courses will satisfy both a TBR General Education requirement AND a requirement of this major. (Other majors may require different General Education courses.) Where specific courses are required for this major,  only those courses are listed under the category. If there are no specific major requirements for a category, all course options appear.

Communication

9 credits, consisting of 6 credits of written composition and 3 credits of oral communication.

Written Composition

Complete both of the following: 

• ENGL 1010 - Critical Reading and Expository Writing (3 credits)
• ENGL 1020 - Critical Thinking and Argumentation (3 credits)

• Students required to complete learning support in writing must enroll in a learning support-designated section (L01-L99) of ENGL 1010  during their first 15 hours at ETSU (not including summer) unless they are also required to complete learning support in reading. Students needing learning support in both reading and writing should enroll in ENGL 1010-Lxx immediately upon completing learning support in reading. Additional information may be found on the University Advisement Center website www.etsu.edu/uac/learningsupport.

   

  Students must earn a grade of “C” or better in ENGL 1010  and ENGL 1020 .

   

Oral Communication

Complete one of the following:

• SPCH 1300 - Introduction to Communication Studies (3 credits)
• SPCH 2300 - Public Speaking (3 credits)
• SPCH 2320 - Argumentation and Debate (3 credits)

Humanities and Fine Arts

9 credits, consisting of 3 credits of literature, 3 credits of fine arts, and 3 credits of humanities electives.

Literature

Complete one of the following: 

• ENGL 2030 - Literary Heritage (3 credits)
• ENGL 2110 - American Literature I (3 credits)
• ENGL 2120 - American Literature II (3 credits)
• ENGL 2210 - British Literature I (3 credits)
• ENGL 2220 - British Literature II (3 credits)
• ENGL 2330 - World Literature (3 credits)
• ENGL 2430 - European Literature (3 credits)

Fine Arts

Complete one of the following:

• ARTH 2010 - Art History Survey I (3 credits)
• ARTH 2020 - Art History Survey II (3 credits)
• BLUE 2150 - American Roots Music (3 credits)
• DANC 1500 - Dance as a Human Experience (3 credits)
• HUMT 2310 - Arts and Ideas I (3 credits)
• HUMT 2320 - Arts and Ideas II (3 credits)
• MUSC 1030 - Introduction to Music (3 credits)
• MUSC 1035 - History of Jazz (3 credits)
• THEA 1030 - Introduction to the Theatre (3 credits)

Humanities

Complete the following:

• ENTC 3020 - Technology and Society (3 credits)

Social and Behavioral Sciences

6 credits, consisting of two of the following: 

• ANTH 1240 - Introduction to Cultural Anthropology (3 credits)

•  

• ECON 1050 - Economics and Society (3 credits) or
• ECON 2210 - Principles of Macroeconomics (3 credits)

•  

• ECON 2220 - Principles of Microeconomics (3 credits)
• GEOG 1012 - Introduction to Cultural Geography (3 credits)
• HDAL 2310 - Developmental Psychology (3 credits)
• HDAL 2340 - Understanding Cultural Diversity (3 credits)
• MCOM 1030 - Introduction to Mass Communications (3 credits)
• PSCI 1110 - Political Life (3 credits)
• PSCI 1120 - Introduction to American Government (3 credits)
• PSYC 1310 - Introduction to Psychology (3 credits)
• SOCI 1020 - Introduction to Sociology (3 credits)
• SOCI 2020 - Social Problems (3 credits)
• SRVL 1020 - Introduction to Service-Learning in the Community (3 credits)
• WMST 2010 - Introduction to Women’s Studies (3 credits)

History

6 credits, consisting of both of the following:

• HIST 2010 - The United States to 1877 (3 credits)
• HIST 2020 - The United States since 1877 (3 credits)

• Note:  HIST 2030 History of Tennessee  (3 credits) may be substituted for 3 credits of United States History.

Natural Sciences

8 credits, consisting of the following lectures and labs:

• PHYS 2010 - General Physics I-Noncalculus (3 credits)
• PHYS 2011 - General Physics Laboratory I-Noncalculus (1 credit)
• CHEM 1110 - General Chemistry Lecture I (4 credits)
• CHEM 1111 - General Chemistry Laboratory I (0 credit)

Mathematics

Students will enroll in the appropriate general education math course during their first calendar year of enrollment at ETSU. Students required to complete learning support in mathematics must enroll in a learning support-designated section (L01-L99) of MATH 1530  during their first 15 hours at ETSU (not including summer) unless they are also required to complete learning support in reading or writing. Students needing learning support in reading or writing in addition to learning support in math should enroll in MATH 1530-Lxx immediately upon completing their other learning support requirements. Additional information may be found on the University Advisement Center website www.etsu.edu/uac/learningsupport/

• MATH 1530 - Probability and Statistics – Noncalculus (3 credits)

Technology Core Requirements: 19 Credit Hours

• ENTC 1510 - Student in University (2 credits)
• ENTC 2170 - CADD (Computer Aided Design Drafting) (4 credits)
• ENTC 3030 - Technical Communication (3 credits)
• ENTC 4017 - Industrial Supervision (3 credits)
• ENTC 4060 - Project Scheduling (3 credits)
• ENTC 4600 - Technical Practicum (4 credits)

Biomedical Engineering Concentration Requirements: 68 Credit Hours

• ENTC 2310 - Electrical Principles (4 credits)
• ENTC 2320 - Electronics I (4 credits)
• ENTC 2330 - Network Systems (3 credits)
• ENTC 3310 - Circuit Analysis (3 credits)
• ENTC 3320 - Electronics II (4 credits)
• ENTC 3331 - RF Fundamentals (3 credits)
• ENTC 3370 - Electronics-Digital Circuits (4 credits)
• ENTC 4277 - Instrumentation and Process Control (4 credits)
• ENTC 4337 - Microprocessors (4 credits)
• ENTC 4347 - Digital Signal Processors (4 credits)
• ENTC 4350 - Biomedical Instrumentation I (4 credits)
• ENTC 4370 - BMET Instrumentation II (4 credits)
• ENTC 4390 - Medical Imaging Equipment Technology (3 credits)
• HSCI 2010 - Anatomy and Physiology I (4 credits)
• HSCI 2011 - Anatomy and Physiology Laboratory I (0 credit)
• HSCI 2020 - Anatomy and Physiology II (4 credits)
• HSCI 2021 - Anatomy and Physiology Laboratory II (0 credit)
• MATH 1720 - Precalculus II (Trigonometry) (3 credits)
• MATH 1840 - Analytic Geometry and Differential Calculus (3 credits)
• MATH 1850 - Integral Calculus for Technology (3 credits)

• Note: MATH 1910 and 1920 may be taken instead of MATH 1720, 1840, 1850. One hour must be compensated for by an advisor approved course.

  • Technical Electives (3 credits)

Minor: no minor required

Transferring Policy

All non-technology coursework such as English, mathematics, and science is evaluated for transfer by an analyst in the Office of Admissions. All technology coursework submitted for transfer will be analyzed by the department chair or the appropriate program coordinator. The following criteria apply:

1. Coursework must have been taken at a regionally accredited two- or four-year institution.
2. Coursework must be equivalent to an ETSU course; if not, it will count as elective credit.
3. Only coursework for which a grade of C or higher was earned will be accepted for transfer credit for courses in English, mathematics, science, and technology.
4. No associate degree coursework will be accepted for Engineering Technology coursework at the 4xxx level.

Upon admission, the transfer student may consult the corresponding academic advisor for an agreement listing the coursework that must be successfully completed by the student.

Students contemplating the transfer of their technology-based associate degree should read the policy statement regarding transfer student admissions elsewhere in this catalog and confer with the corresponding academic advisor with the Department of Engineering Technology, Surveying, and Digital Media.

Additional Information

Click here to view the Biomedical Engineering Technology Concentration Suggested Course Sequence