| |
Nov 21, 2024
|
|
|
|
|
2010-2011 Undergraduate Catalog [ARCHIVED CATALOG]
Engineering Technology Major, B.S. (Electronics Engineering Technology Concentration)
|
|
 Return to: Programs A – Z
|
General Program Information
ETSU Academic Proficiency Requirements:
Writing: Students must complete a minimum of four writing-intensive courses. At least two of these courses must be in the major field of study. At least two of the four courses must be at the 3000-4000 level.
Oral Communication: Students must complete a minimum of two oral communication-intensive courses. At least one of these courses must be in the major field of study.
Using Information Technology: Students must complete at least one using information technology-intensive course in the major field of study.
Transfer students may be subject to reduced number of intensives.
See ETSU Academic Proficiency Requirements for details. Electronics Engineering Technology Concentration
This program is accredited by the Technology Accreditation Commission of ABET, 111 Market Place, Suite 1050, Baltimore, MD 21202-4012 – telephone: (410) 347-7700. This concentration emphasizes electronics specialties in the areas of Telecommunications and Instrumentation and Automation. It prepares individuals for job opportunities in all areas of electronics with selection of the general specialty. TBR General Education Core Requirements: 41 Credit Hours
Technology Core Requirements: 19 Credit Hours
Additional Requirements: 68 Credit Hours
Electronics Electives: 11 Credit Hours
Select from the following: Specialty Electives: 11 Credit Hours
Select (1) One Area: General:
- Choose 11 credit hours from courses listed above.
Total Hours Required for Degree: 128 Credit Hours
To Students Transferring into the Electronics Engineering Technology Program at ETSU
All students, including transfer students, must complete the published curriculum in electronics engineering technology in effect the year of their entry into the program. All students transferring into the B.S. degree electronic engineering technology program must take a minimum of four electronics courses that must include ENTC 3310 —Circuit Analysis. No associate degree coursework will be accepted for electronic coursework at the 4XXX level.
If the transfer student is from a program that is not accredited by the Accreditation Board for Engineering and Technology (ABET), the required minimum must also include ENTC 3320 —Electronics II. It is the students’ responsibility to provide evidence that the transferred coursework was completed at an ABET-accredited institution. (This information would usually be found in the school’s catalog.) |
Return to: Programs A – Z
|
|